Αποτελέσματα Αναζήτησης
The GA 35, GA 36, and GA 37 antennas include GPS/WAAS antennas and GPS/WAAS with SiriusXM combination antenna. The coax cable interface to the receiving equipment provides both power to the antenna preamp from the receiving equipment and signal back to the receiving equipment.
The GA 3X Series antennas includes GPS/WAAS antennas and GPS/WAAS with XM combination antenna. The coax cable interface to the receiving equipment provides both power to the antenna preamp
Garmin GPS and XM® Antenna STC Installation Manual Page 1-1 190-01284-00 Rev. B 1 GENERAL DESCRIPTION 1.1 Introduction This manual presents mechanical and electrical installation requirements for installing the Garmin antennas listed in Table 1-1 and the information contained herein is STC approved. 1.2 Scope
If the antenna is removed and replaced, verify proper operation by successfully completion of the self test of the interfaced receiving equipment. Penetration of the pressure vessel of a pressurized aircraft is not approved under this STC installation.
Page 76: Figure 5-10 Backup Gps Antenna Installation (Hook And Loop Example) Backup GPS Antenna Removal Use the following procedure to remove the Backup GPS antenna: 1. Remove power from the GI 275 connected to the Backup GPS antenna. 2. Disengage the BNC connector from the GI 275. 3.
1.5.2 Optional GPS Antenna The G5 includes a built-in GPS receiver with an internal antenna that can be used in many installations. A Garmin or non-Garmin GPS antenna is optional for G5 installations when not using the G5's internal GPS antenna.
This external, active GPS antenna is suitable for all WAAS panel-mount GPS systems. The low-profile, teardrop antenna provides excellent reception, and it attaches through the fuselage via screw mount, sharing the same hole pattern with the GA 56 antenna.
