Αποτελέσματα Αναζήτησης
Using the V-Force wiring pin out chart (pgs. 3 & 4) locate the correct wiring color and location of the TPS for your vehicle. After locating the TPS you will note that the TPS has THREE wires going to it.
We offer JET Performance carburetors, modules, JET Performance chips, and more. These JET Performance Products will give you more power in your vehicle.
Use the V-Force / PCU wiring chart to determine the correct wire color and if you will be connecting to the MAP or MAF sensor (Most vehicles will be con- necting to the MAP. There will be a note on the wiring chart for your specific vehicle if your vehicle connects to the MAF). CUT the wire color that matches
Plug the factory harness into the JET CAGS Skip Shift. Secure the factory harness and skip shift with the supplied tie wrap to keep the harness and skip shift with the
The Jet Performance Module is designed to enhance the performance and driveability of your vehicle. By optimizing the air/fuel ratio, ignition advance and various other parameters, the Jet Module retunes your engine for maximum performance. The use of premium fuel (91 octane or higher) is recommended for maximum results. Lower
Before you have any work done on the vehicle that you feel may have been related to the JET Per-formance Chip or Module, please call JET at 714-848-5515. JET Performance Products warrants Chips and Modules to be free from defects in material and workmanship under normal use and if properly in-stalled.
The chart below can be used as a guide when correlating main metering jet part numbers to secondary metering plates. This is necessary when converting the secondary metering plate to a metering block, with replaceable jets, as with the conversion kits listed above.
