Αποτελέσματα Αναζήτησης
In this study it will be investigated the defect of seam slippage in satin fabrics and factors cause minimizing of this problem. For experimental work, three satin materials are sewn in warp, weft and Bias’s direction with three stitch types in three levels of stitch length by 2 needle sizes, are chosen.
A new fractal model for predicting the permeability of satin fabrics is proposed mainly based on the fractal theory. The repetitive unit was selected first according to the structural characteristi...
For experimental work, three satin materials are sewn in warp, weft and Bias’s direction with three stitch types in three levels of stitch length by 2 needle sizes, are chosen. Results of each factor are separately presented and analysed.
materials. I. Introduction Seam failure in garment can occur because of either the failure of the sewing thread leaving the Fabric intact or fabric rupture, leaving the Sean intact or both breaking at the same. Seam strength is testing in almost the same manner as fabric breaking and strength.
This research is an experiment that uses bridal satin material as an object, with the technique of hammering ecoprint on the leaves using tohor limestone mordans and tunches. The primary data in this study was collected through questionnaires.
22 Ιουλ 2023 · Plain, twill, and satin structures, made from cotton, were produced from warp ring-spun yarn and weft open-end spinning yarns . The air and water permeability, thermal resistance, water absorption, and stiffness of the prepared textiles were measured to study the overall fabric comfort.
22 Νοε 2016 · PLA (poly lactic acid) is a degradable Eco-friendly material which is made from corn or other crops, it also can be used in the textile engineering, and the PLA filament has good mechanical properties, such as high break elongation rate
