Αποτελέσματα Αναζήτησης
- Lift the hood to open the drain. The stopper should lift to approximately 3/8” (1cm). If it does not, remove the lift rod assembly. - If the stopper does not lift high enough, use the adjusting screw to adjust the spring downward. If the stopper lifts more than 3/8” (1cm), adjust the spring upward. 7. Installation Checkout - Ensure that ...
View and Download Kohler Clearflo K-7160 installation instructions online. Bath drain. Clearflo K-7160 plumbing product pdf manual download. Also for: Clearflo k-7160m, Clearflo k-7161, Clearflo k-7161m.
ATTACHED LIFT ROD ASSEMBLY MODELS: Position the lift rod assembly directly on the drain stopper. Adjust the assembly length so the alignment ribs of the overflow hood line up with the top edge of the overflow hole in the bath. Refer to the illustration. Insert the lift rod assembly into the overflow ell. Tighten the overflow hood to the ...
manufacturer’s instructions. Locate the center hole and insert the spout. Position the metal washer so the second hole lines up with the drain lift rod hole on the back of the spout. Securely tighten the nut with a wrench. Do not overtighten. Remove any excess putty or sealant. Apply Plumbers Putty Putty Ring (if included) Metal Washer Nut
ATTACHED LIFT ROD ASSEMBLY MODELS: Choose the lift rod that extends most closely to the necessary length as shown. Use pliers to spread top loop of lift rod apart. Insert end of loop into hole in end of overflow hood lever. Close lift rod loop with pliers. Lift Rod Loop Lift Rod Assembly Fig.#9 9 Insert lift assembly into the overflow ell ...
Page 11: Install Lift Rod Attacher la boucle de la tige de levage sur le levier situé sur l’arrière de la poignée. Utiliser des pinces pour fermer la boucle doucement afin de la fixer sur la poignée.
ATTACHED LIFT ROD ASSEMBLY MODELS: NOTE: Choose the lift rod that extends most closely to the necessary length, as shown. Insert crank of the overflow hood into the loop of the lift rod, nip the top end of crank with long flat nose carefully and then thread the washer through the top end of crank. Insert the lift rod assembly into the overflow ...
