Αποτελέσματα Αναζήτησης
18 Ιουν 2015 · I've heard those buckshot molds want to be run hotter than your boolit molds. I've only used the sharpshooter mold. When I'm getting good casts, the wood handles are starting to smolder a bit.
- Any Tips For Casting #4 Buckshot From A Lee 18-Cav Mold #90028?
The mold in the picture would cast 40 #4 buckshot in a...
- Any Tips For Casting #4 Buckshot From A Lee 18-Cav Mold #90028?
8 Μαΐ 2023 · Lee, 18 Cavity, Aluminum, .240 Cal., #4 Buckshot Casting Mold, This mold took some serious practice to get usable buckshot pellets from, it just takes "Time ...
6 Ιουλ 2021 · The mold in the picture would cast 40 #4 buckshot in a single drop. The inlets were quite small so pressure-casting and hot alloy and mold were important. I'm not sure if graphite (Molykote powder) will improve patterns, I did try to tumble some, and they turned out much slicker than the naked lead balls,
9 Μαρ 2017 · The lead is usually 92-6-2 allot since I have an Automated Master Caster to cast large volumes of common pistol bullets but some times I have another alloy in the Lee bottom pour pot used with the Sharp Shooter mold. A little hard lead seems to work best for the #4 buck shot.
2 Νοε 2008 · The ONLY way I would cast buckshot is if I found a #2, #3, or #4 6 gang mold. Then I would cast from WW and drop into cold water to harden the surface. Right now I use #2, 3, &4 buck in STEEL/TUNGSTEN wads, buffered and get 20 inch patterns at 40 yards using an 11-87 12 bore with vented Primos .665 choke.
Feature trochoidal venting on the mold face and sprue plate mating surface. Unique venting allows consistent and effortless fill out. Precision-machined mold produces 18 linked pellets per cast, allowing one to easily cast over 2000 pellets an hour. Bullet mold handles sold separately.
2 Νοε 2013 · I have had good luck with these Lee molds. For best results, you must keep them sooted up with a match on the cavities, and keep them up to temperature by se...
