Αποτελέσματα Αναζήτησης
25 Ιουλ 2015 · However, there are a few options one can do to repair, replace, or modify the unit to make it work as good as or better than new. Option 0: Bypass the power ‘snap’ switch and plug the unit into a 120VAC wall receptacle that has its own wall switch, or put a toggle switch in the unit’s power cord. (Option ‘0’ for “nope”.)
Many of the parts such as controls, pots, switches and knobs MAY* also fit Kenwood KR-3090, KR-4070, KR-5030 & KR-6 030 model s. - PARTING OUT - Kenwood KR-5030 / KR-5330 STEREO RECEIVER PARTS / SPARES
10 Μαΐ 2017 · I recently got back into analog audio and older audio gear and got my hands on a nice Kenwood KR-4400 receiver. One problem: the volume-balancepot is worn out and has to be replaced. I have replaced some pots and resisters on several basses and done some DIY stuff (also built a custom arcade cabinet) but I'm not a skilled tech.
For now I am glad the problem is fixed, but for a permanent solution I am going to try and rig up a solution using a high amp rated NC (normally closed) switch or relay. I'm still debating what to do.
4 Μαρ 2008 · I have an older but still beloved Kenwood receiver, (I think it's a KR-V8070) Early 5.1 surround sound, etc. I had stored it for a while, but was using it to supply a low level signal for some woofer repairs. This particular unit actually has a switch on the back that allows for changing the stability of the output depending on what the impedance
16 Νοε 2023 · After more troubleshooting it seems the power selector switch (switches between off, speaker A, Speaker B, and Both) is the issue. If I touch it and apply any amount of pressure I can cause the issue to happen.
2 Απρ 2020 · There are a few fixes that can be found online that include cleaning the switch and replacing the wiper or installing a relay. The KR-4070 measures 5 7/8″ x 18 1/2″ x 11 13/16″ and weighs just under 21 pounds. Despite its minor issues the Kenwood KR-4070 is a great receiver.
