Αποτελέσματα Αναζήτησης
IP address of your access point By factory default, the IP address will be assigned by a DHCP server (usually the network router) If there is no DHCP server on your network, the default IP address is 192 168 1 252/255 255 255 0
If there is no DHCP server on your network, the default IP address is 192.168.1.252/255.255.255.0. Note—Use a computer hardwired to the same network as your access point for browser -based
IP address on the access point (The default IP address for the access point is 192 168 1 252 ) If you use this method, you will need to reconfigure the cabling for subsequent
This article lists the steps in changing the LAN IP address of the access point. NOTE: When changing the LAN IP address of the access point, make sure it uses the same segment as your network. Step 1: Access the access point’s web-based setup page. For instructions, click here.
If you have a 48VDC Power Injector (e.g. Linksys WAPPOE), power up your Access Point first, then connect the Injector’s cable to your PC. Configure your PC to have the static IP address on the same subnet as the Access Point’s default IP address (192.168.1.245).
29 Μαρ 2007 · Solution: Logging into the Linksys Router. Note: 192.168.1.1 is the default IP address of the router. If you changed this IP address, then you need to use the new IP address in order to access the router. The default username is blank.
Access Control By default, no IP addresses are prohibited from accessing the device’s admin page. You can enable access control and enter specified IP addresses for access. Four IPv4 and four IPv6 ad- dresses can be specified.
