Αποτελέσματα Αναζήτησης
Chapter 3: Floor Framing. Step 1–Crown and Place Joists Steps 2 and 3–Nail Rim Joists in Place and Cut Joists to Length Step 4–Nail Joists in Place Step 5–Frame Openings in Joists Steps 6 and 7–Block Bearing Walls and Nail Joists to Walls Step 8–Drywall Backing Step 9–Subfloor Sheathing.
WEYERHAEUSER FRAMER SERIES® LUMBER WITH WARPSTABLETM TECHNOLOGY. Structural Framing Lumber with Predictable Performance. Computerized grading virtually eliminates warp. Comes with crown edge clearly marked. Eliminates field culling. Treated with a mold inhibitor. More stable and consistent than ordinary lumber. Limited product warranty.
1) Wall studs shall not be notched, drilled or otherwise damaged so that the undamaged portion of the stud is less than two-thirds the depth of the stud if the stud is loadbearing or 40 mm if the stud is non-loadbearing, unless the weakened studs are suitably reinforced.
U.S. WALL GUIDE. Featuring Trus Joist® TimberStrand® LSL and Parallam® PSL Wall Framing. Engineered to meet code requirements for walls up to 30' tall. Easy-to-use tables adaptable to a variety of wind conditions, surface finishes, and wall layouts.
Advanced framing with 2x6 wood studs spaced 24 inches on cen-ter, combined with wood structural panel sheathing, is one of the most cost-effective solutions for builders trying to balance increasingly strin-gent energy codes with structural building code requirements.
Stud Framing . o Stud spacing, notching and boring per Table 2 and Figures 2 and 3. Fig 2: Notching and bored hole limitations for exterior walls and bearing walls. Fig 3: Notching and bored hole limitations for interior nonbearing walls. Studs must fully bear on minimum 2x nominal sole plate (R602.3.4).
Design Load Tables for Wood Columns (Posts) 4x4 through 12x12. Incised 4x4 and 4x6. In a wood structure, whether it is a deck or a five-story wood frame building, solid wood columns (posts) are often used. These columns are subject to axial compressive loads, and in some cases, eccentric loads.
