Αποτελέσματα Αναζήτησης
Important Note: Your wall switch may have two wires attached to the same screw (see illustrations below for examples). Tape these two wires together before disconnecting.
Replacing a standard light switch with a single dimmer is a pretty simple do-it-yourself project. In about 15 minutes you'll have the ability to adjust the light in a room for any activity - and you'll save energy. Use the tool below to help you install a single pole, 3-way, or multi-location dimmer, switch or sensor. 1en/us/en.
3-Way Wiring: † Connect the green Dimmer ground wire to the bare copper or green ground wire in the wallbox. (See Important Note 4 and 5.) † Connect the black Dimmer wire to the wire removed from the different-colored screw on the switch. If you had taped together two wires, connect both wires to the black Dimmer wire. Remove tape from wire.
Technical Support Wiring Tool Diagrams 3684493 h 05.12.2021 Not sure this is the correct wiring for your Lutron product? For more information, refer to the Lutron DIY Wiring Tool or visit the Lutron Support Center.
View support resources for the full range of Maestro light controls, dimmers, fan controls, sensors and timers.
The MACL-153M will wire to one mechanical switch in a three way application. This requires a wiring adjustment at the three way switch where in you will be just using two connection points on the mechanical switch instead of the standard three.
29 Δεκ 2022 · The entire procedure of wiring a Lutron 3-way dimmer switch will be described sequentially throughout this segment. I will also provide a wiring diagram so that you may find it easier to make the necessary connections needed.
