Αποτελέσματα Αναζήτησης
Refer to Calibration Gas in Fleet Manager II. Attach a 0.5 ml/min regulator to the gas cylinder. To perform an automated calibration, use a demand flow regulator and refer to the MicroDock II User Manual. Connect the calibration hose to the calibration cap.
reset by pushing RESET button on the alarm. This will reset the EOL Signal for a period of 48 hours (2 days). Do not disconnect the Alarm until you have a replacement Alarm available to install.
Page 17 • If the gas monitor is not used for a long time, turn on the power at least once every six months and check that the pump draws in air. The gas monitor, when not activated for a long time, may cease to work because of hardening of the grease in the pump motor.
To ensure personal safety, read the Safety Information - Read First and Cautions before using the detector. The GasAlertMicro 5, GasAlertMicro 5 PID, and GasAlertMicro 5 IR gas detectors (“the detector”) warn of hazardous gas at levels above user-defined alarm setpoints. The detector is a personal safety device.
The alarm levels for the individual gases are factory-set and can be changed through the Setup Menu. These changes can also be made through MSA Link software. Ensure that the latest version of the MSA Link software has been downloaded from MSA’s website www.msasafety.com. NOTE: If gas is present during Fresh Air Setup, the device will fail ...
• Calibrate the detector before first-time use and then on a regular schedule, depending on use and sensor exposure to poisons and contaminants. Sensors must be calibrated regularly and at least once every 180 days (6 months).
15 Μαΐ 2019 · Read and understand this instruction manual before operating instrument. Improper use of the gas monitor could result in bodily harm or death. Periodic calibration and maintenance of the gas monitor is essential for proper operation and correct readings. Please calibrate and maintain this instrument regularly! Frequency of calibration
