Αποτελέσματα Αναζήτησης
26 Νοε 2020 · Look at the lights on the charger unit – an alternating flashing red and green light means that the battery is faulty. In this instance take the battery back to the dealer that you bought it from and they should be able to help you. 4) Finally check the nails and fuel that you are using.
30 Δεκ 2011 · A Paslode Cordless Angled Finish Nailer battery usually stops charging if the charger is experiencing technical difficulty or if the battery is faulty or dead. The battery, which controls the tool's nail cycle rate and continuous operation, must be charged in order maximize the nailer's performance.
Check these six things to get your nailer immediately back to work—for more detailed instructions, check your nailer's operating manual: 1. Check fuel cell expiration date. 2. Check for empty fuel cell by tapping valve upward against firm object (look for mist) 3. Battery charge — check for flashing green light. 4. Dirty filter. 5.
17 Αυγ 2023 · While running some checks on the repaired chargers I noticed the voltage on the centre connector was about 2.7V on one battery and floating at 5V on the other battery. With the battery off the charger and checking with the multimeter I could measure between the negative and centre connectors about 12Kohms at room temperature on one battery and ...
experiencing problems with your tool, here are a few easy suggestions to help keep you going. firing brads - just leaves an indentation or blank shots. Intermittent firing/ won’t fire properly. Fan running constantly. Check fuel is in date (see base of fuel) and that the fuel cell is not too cold.
13 Αυγ 2021 · If there is an alternating flashing red and green light, then your battery is faulty. Also, make sure the battery is fully charged before you operate the nail gun. Finally, check the nails and fuel that you are using. Try switching the nails and fuel cell independently to see if they fix the issue.
Check for a damaged or exhausted battery if the lights on the charger flash red/green for more than 20 minutes. If it does not turn and the tool indicator light is blinking red or solid red, the battery is not charged or the battery terminals are corroded or dirty.
