Αποτελέσματα Αναζήτησης
USB interface to the computer, and then insert (all the way) the interface’s phono plug into the corresponding “Trainer” jack in the center of the rear of the DX6i, with the radio’s power switch still in the “off” position.
To begin, connect your genuine Phoenix USB interface to a spare USB port on your computer. Once you have done so, you should connect any additional adaptors (if required) to the 3.5mm “jack plug” end of the USB interface.
13 Φεβ 2024 · Posted February 13. If you see messages telling you no transmitter is detected, you're unable to calibrate. Is your Supersim 'lead' just a dongle that is a usb connector at one end an a mini phono jack socket at the other?
15 Αυγ 2010 · Phoenix RC and Hitec sim cable. Hello, Some time ago I bought a Hitec Aurora 9. Also I bought USB Sim - Interface with ordernumber: #11 0650, but it's called also: PN 58315. So I did all that was written in instructions. Put in Usb cable in PC, then in Aurora 9.
This document provides an introduction and overview of the Phoenix RC flight simulator. It discusses getting started with Phoenix including minimum system requirements, supported transmitters, and how to install and connect a transmitter to Phoenix using a USB interface.
30 Δεκ 2012 · To get the most out of your Phoenix flight simulator you will need to set it up correctly. This will be covered: Configuring your transmitter; Calibrating the transmitter; Learn to adjust settings according to skill level; The guide is intended for: Phoenix flight simulator 3.0 or later; Spektrum transmitter; What's being used for demonstration:
16 Σεπ 2021 · I created a short ' how to' video from my PhoenixRC installation and setup for using a USB controller cable.
