Αποτελέσματα Αναζήτησης
For these steel grades, flatness tolerance values shall be specified at the time of enquiry and order. In this section you will find conversion tables, a table comparing hardness values and correspondence tables between tensile strength and hardness.
ASTM A480 Plate Thickness & Flatness Tolerances. * Thickness is measured along the longitudinal edges of the plate at least 3/8 in. [9.52mm], but not more than 3 in. [76.20 mm], from the edge. ** For plates up to 10 in. [254.0mm], excl, in thickness, the tolerance under the specified thickness is 0.010 in. [0.25 mm].
Browse Hot Rolled Steel Tolerances over/under specifications to find the right size and material for your next project at OnlineMetals.com.
ISO 7452:2013 specifies requirements for tolerances for hot-rolled steel plates made on a reversing mill with the following characteristics: nominal thickness: 3 mm ≤ t ≤ 400 mm; nominal width: w ≥ 600 mm. ISO 7452:2013 does not apply to stainless steel.
tolerances for hot-rolled non-alloy and alloy steel plates including stainless steels with the following characteristics: a) nominal thickness ≥3mm ≤250 mm; b) nominal width ≥600 mm; c) specified minimum yield strength < 700 N/mm 2. Tolerances for products of width < 600 mm cut or slit from plate should be agreed between
Nominal thickness: 3 mm ≤ t ≤ 400 mm; Nominal width: w ≥ 600 mm. Tolerances for products of width w < 600 mm cut or slit from plate should be agreed between manufacturer and purchaser at the time of enquiry and order. This European Standard applies, but is not limited, to steel grades defined in EN 10025-2 to.
PLATE AND FLOORPLATE ROLLED ON A PLATE MILL Thickness tolerances given are applicable to plate and floorplate in all edge conditions, with a specified or typical minimum yield strength of 360 MPa or less. For steels with a specified or typical minimum yield strength greater than 360 MPa, the thickness tolerance is determined by multiplying the ...
