Αποτελέσματα Αναζήτησης
26 Απρ 2011 · The main tricks given in the video are about the actual set up bearings. The rear end being worked on is a 8.5 inch gm 10 bolt out of a second generation f body. Tooth contact pattern charts...
See how to set up a ring and pinion gear set. TIMELINE:0:00 Introduction0:22 Pinion gear examples 0:40 Pinion bearing locations 0:48 Oil splash shield and se...
We are overhauling a Dana 44 (216RBI). This recording was live, no edits, and it spans from the beginning to the end of the overhaul.
17 Οκτ 2022 · This increases the carrier bearing preload and the backlash at the same time. Shop Re-Gear Kits. This quick primer of tech tips is designed to be informational for less experienced installers and a refresher course for seasoned differential technicians.
The rearend gear ratio refers to the relationship between the driven gear (ring) and the drive gear (pinion), and is easily calculated by dividing the ring gear tooth count by the drive gear tooth count.
19 Φεβ 2016 · Learn how to visually identify rear axles. This guide includes ford rear-end identification, Dana axle identification, and common GM rear-end identification tips.
An installation guide sheet will be included in each AAM gear set, indicating the gear type (two-cut or five-cut). The set up of a gear set can be accomplished by first measuring the carrier pinion depth. Install measuring tools and tighten to 18 in. lbs.
