Yahoo Αναζήτηση Διαδυκτίου

Αποτελέσματα Αναζήτησης

  1. 11 Ιουν 2020 · I have ran into an issue which has never come across before regarding a frequency that I cannot tune into my zgemma h2s STB. I have a 80cm dish with a universal LNB pointing at 13E. Underneath this is a sky dish pointing towards 28.2E.

  2. 19 Ιουλ 2005 · Signal strength across the board for Hotbird is roughly 70-75%, however Pic Quality varies. Once it gets down to 20% or below I either get massive pixilation or no picture at all. There are also a number of frequencies which don’t even register, although the signal strength is there.

  3. 9 Απρ 2009 · To get the frequency on the wire you subtract the LNB local oscillator frequency (LO) from the transponder frequency (TP). A Universal LNBF will normally have a low LO of 9750 and a high LO of 10600, selected via 22Khz tone.

  4. 19 Ιουν 2024 · .If your satellite antenna is set up correctly and you have a signal on Hotbid 13 E, but you don't have a signal on those channels, most likely you need to change the LNB head because it is possible that your LNB head is defective.

  5. Documented Satellite TV charts dedicated to European viewers. Satellite and channel information updated daily.

  6. Documented Satellite TV charts dedicated to European viewers. Satellite and channel information updated daily.

  7. 3 Νοε 2003 · I get a good signal from Hotbird 3 frequency 12245 but transpoder 75 (12211) is very faint and my Humax f1 vaci says "No signal" after scanning for 2 mts. Anybody her to help. Thanks M

  1. Γίνεται επίσης αναζήτηση για