Αποτελέσματα Αναζήτησης
The information below will give you an idea of the size and weight of every Shilen barrel contour. Dimension "C" is the barrel diameter at dimension "F". * The stamped end of the barrel is the chamber end. * You must cut 1" off each end of the barrel.
- Drop-In Barrels for Ruger Precision Rifles
Drop-In Barrel for Ruger Precision® Rifles (RPR) Shilen...
- Calibers Twists
In a 16"-twist barrel, the bullet makes one revolution in 16...
- Barrel Grades
CONTOURS PRE-THREADED & CHAMBERED BARRELS AR15 BARRELS LFAR...
- Chambers
rifle barrels - - - - - - - - - - barrel grades calibers &...
- Savage Replacement Barrels
rifle barrels - - - - - - - - - - barrel grades calibers &...
- Drop-In Barrels for Ruger Precision Rifles
[4] Contours only available on barrels for the Rem 700 either prethreaded and chambered or installed by Shilen.
Upgrade the performance and accuracy of Remington 700 rifles without costly stock work. Match-grade, short-chambered barrels have the correct contour to drop into Remington factory or aftermarket stocks with little-to-no barrel channel modifications. Install with your factory recoil lug.
Welcome to Shilen Rifles, Inc. Products::Rifle Barrels. Please select your area of interest from the menu categories at the left. Since 1986, Tony Boyer of Keezletown, Virginia, has literally dominated benchrest competition in this country.
These barrels, supplied already threaded, chambered, crowned and polished by Shilen, are available in all Shilen contours and chamberings. To complete a beautifully precise fitting job, the gunsmith must add just a few finishing touches.
Northland Shooters Supply (NSS) currently stocks Shilen Savage prefit hand-lapped match-grade barrels for your Savage Arms receiver (Savage Replacement Barrels) in both small and large shanks manufactured by Shilen Rifles Inc.
The information below will give you an idea of the size and weight of every Shilen barrel contour. Dimension “C” is the barrel diameter at dimension “F”. Reminder: * The stamped end of the barrel is the chamber end. * You must cut 1″ off each end of the barrel.