Αποτελέσματα Αναζήτησης
15 Ιουλ 2013 · If IP routing is disabled (i.e. 'no ip routing or a 3560 acts as Layer 2 only) or unsupported (2960), we issue the 'ip default-gateway' global config command. This is similar to assigning the default gateway IP address on a PC.
Okay, I followed the instructions with my PT labs but for some reason when I run a "show ip route" command on Router 2 and Router 3 the OSPF feature does not show. However, when running the same command it shows just fine in Router 1. Here is the topology I'm working with:
Troubleshooting OSPF. We can begin our troubleshooting by looking at the output of the ‘show ip ospf neighbor’ command. Router# show ip ospf neighbor Neighbor ID Pri State Dead Time Address Interface 2.2.2.2 1 FULL/DR 00:00:39 1.1.1.2 GigabitEthernet0/0
To display IP Open Shortest Path First (OSPF) nonstop routing (NSR) status information, use the show ip ospf nsr command in privileged EXEC mode. show ip ospf [process-id] nsr [ [objects] | [statistics] ]
1 Απρ 2015 · The initial step that you should take with attempts to resolve the OSPF-CONFLICTING_LSAID error message is to locate the prefix that is not advertised as well as the prefix that conflicts. In order to locate these, enter the show ip route and show ip ospf database commands into the CLI.
Use the ip default-network and ip route 0.0.0.0 0.0.0.0 commands to set the gateway of last resort on Cisco routers that have ip routing enabled. The way in which routing protocols propagate the default route information varies for each protocol.
14 Αυγ 2023 · Check the OSPF neighbor table on the neighbor router with the show ip ospf neighbor command, and perform the same configuration verification actions listed earlier in this document in the No State Revealed section.
