Αποτελέσματα Αναζήτησης
TESTING THE SYSTEM The TEST key puts your system in Burglary Walk Test mode, which allows each burglary protection point to be checked for proper operation. Testing should be conducted weekly to ensure proper operation. • The keypad sounds a single beep about every 30 seconds as a reminder that the system is in the Test mode.
In addition, Yuasa NP4-12 entry into the Test mode initiates a battery test. The VISTA-128B PLUS also runs a 5-second Yuasa NP7-12 battery test every 60 seconds to check if the 12AH Yuasa NP12-12 Fits in large battery is connected. Page 55: Program Modes
View and Download Honeywell VISTA-128BPTSIA quick manual online. VISTA TURBO BURGLAR SERIES. VISTA-128BPTSIA security system pdf manual download. Also for: Vista-128bpt, Vista-250bpt.
TESTING THE SYSTEM The TEST key puts your system in Burglary Walk Test mode, which allows each burglary protection point to be checked for proper operation. Testing should be conducted weekly to ensure proper operation. • The keypad sounds a single beep about every 30 seconds as a reminder that the system is in the Test mode.
• Refer to the User Guide for procedures on Testing the System. • During Test mode, no alarm reports are sent to the central monitoring station. NOTE: All references to the VISTA-128BPT also pertain to the VISTA-128BPTSIA.
Refer to System Communication section in the VISTA-128BPT/VISTA-250BPT Installation and Setup Guide for detailed instructions. Then use #93 menu mode to program report codes.
• Use the Go/No Go Test mode to verify adequate signal strength from each transmitter location: Enter Installer code + [#] + 4, then fault each transmitter and listen for 3 beeps at the keypad and the zone display. Exit mode: user code + 1 (OFF). 5. Connect the external sounder to terminals 3 and 4.
