Αποτελέσματα Αναζήτησης
Currently, the Overall Distance Standard, which defines the maximum yardage golf balls can travel, is set at 317 yards (with a tolerance of 3 yards). Golf balls are tested according to three established launch conditions: clubhead speed (120 mph), launch angle (10 degrees) and spin (2520 rpm).
Golf Ball Testing. A golf ball manufacturer submits two dozen balls of each model to the USGA for conformance testing. The technical staff conducts the testing of more than 20,000 golf balls per year for conformance using a combination of simple measurements and state-of-the-art testing devices.
1 ημέρα πριν · In the GOLF/Golf Laboratory testing, analysts tested about 40 balls and all had spin rates that exceeded 6,300 RPM. A lower number would mean lower performance overall. When discussing spin rate, a good rule of thumb is that the rate for a drive depends on the speed of your swing. A slower swing may be required for a higher spin rate, and vice ...
Key Findings. High Swing Results. Mid Swing Results. Low Swing Results. The Data. FAQ. About the 2023 Golf Ball Test. MyGolfSpy’s 2023 golf ball test took place at two locations and involved more than 80 hours of testing time. Forty-six golf ball models were tested at three speeds each with drivers and mid-irons.
Introduction . Following are the general policies and procedures regarding the submission process for manufacturers wishing to submit golf balls to the USGA for conformance evaluation, including the updated conformance testing submission deadlines.
The decision aims to reduce the impact increased hitting distances have on golf’s long-term sustainability while minimizing the impact on the recreational game. The revised ball testing conditions will be as follows: 125-mph clubhead speed (equivalent to 183 mph ball speed); spin rate of 2200 rpm and launch angle of 11 degrees.
6 Δεκ 2023 · The revised ball testing conditions will be as follows: 125-mph clubhead speed (equivalent to 183 mph ball speed); spin rate of 2220 RPM and launch angle of 11 degrees.
