Αποτελέσματα Αναζήτησης
Remove the Shift Boot From within the car, lift up on the shift boot, a prying it off the console with your hands, by pulling on either side of it to release the clips holding it down. At this point, if you have an illuminated shift knob, disconnect the wires at the clip-together connection. Page 2 of 16 * updated 04/11/2014
Installation Instructions for the EV03 Height-Adjustable Ultimate Short Shifter for 1994-1999 M3, 1996-2000 328, 2001-2004 330, 2001-2004 M3 models only Thank you for purchasing the Ultimate Shift Kit. Please read these directions thoroughly and become familiar with the procedure.
UUC installation guides. All files in Adobe .pdf format. Requires Adobe Reader. Big brake kits (installation guides coming soon) Short Shifter kits (Evo3) Lightweight flywheel kits (Twin Disk and Single Disk) Underdrive pulley kits. Leather shift boots and parking brake boots. Camber plates.
Step 11 — Install UUC Motorwerks shifter assembly in place of stock assembly. properly. Tighten the lower pivot bolt and nut so that it allows the lower linkage bracket to move without binding. After tightening the pivot, maneuver the entire shifter assembly through the top of the
CNC-machined stainless steel lower section features integral pivot ball and self-adjusting primary pivot bearing. No welds, no plastic. Special features that make the "Ultimate Short Shifter" unique: 100% CNC-machined 303 stainless steel construction.
Rob Knob/RK Evo Shift Knobs Thank you for purchasing the UUC Motowerks Rob Knob/RK Evo Shift Knob. Please follow the following directions for many miles and shifts of trouble free performance. Included in the Rob Knob/RK Evo are: - Aluminum (or Titanium) Rob Knob/RK Evo - Delrin knob insert - 5mm stainless steel set screw - 2.5mm Allen key ...
Remove the Shift Boot From within the car, lift up on the shift boot, a prying it off the console with your hands, by pulling on either side of it to release the clips holding it down. At this point, if you have an illuminated shift knob, disconnect the wires at the clip-together connection. Remove the shift knob by pulling straight up with a
