Αποτελέσματα Αναζήτησης
By default, Aruba controllers and access points treat ports as untrusted. However, certain ports are open by default only on the trusted side of the network. These open ports are listed in Table 1. This is use for certain types of VPN clients that accept a banner (QOTD).
- Firewall_Port_Info
This section describes the network ports that need to be...
- Firewall_Port_Info
Understanding Default Open Ports. By default, Aruba managed devices and access points treat ports as untrusted. However, certain ports are open by default only on the trusted side of the network. These open ports are listed in Table 1.
This section describes the network ports that need to be configured on the firewall to allow proper operation of the Aruba network. Between any two controllers: IPsec (UDP ports 500 and 4500) and ESP (protocol 50).
Configuring Communication Ports. Most of the communication between devices on the remote site and Aruba Central server is carried out through HTTPS Hypertext Transfer Protocol Secure. HTTPS is a variant of the HTTP that adds a layer of security on the data in transit through a secure socket layer or transport layer security protocol connection.
Enabling or disabling ports and configuring port mode. You can configure one or more of the following port parameters.
To configure port C5 for auto-10-100, enter this command: switch(config)# int c5 speed-duplex auto-10-100. To configure ports C1 through C3 and port C6 for 100Mbps full-duplex, enter these commands: switch(config)# int c1-c3,c6 speed-duplex 100-full.
27 Ιαν 2012 · The following ports must be enabled before configuring the VIA controller. TCP 443—During the initializing phase, VIA uses HTTPS connections to perform trusted network and captive portal checks against the controller.
