Αποτελέσματα Αναζήτησης
• The appliance is intended to 'soften' the water, meaning it will remove hardness minerals; it will not necessarily remove other contaminants present in the water. The appliance will not purify polluted water or make it safe to drink! • Installation of the appliance should only be undertaken by a competent
OPERATING PRESSURE MIN-MAX: 1,4-8,3 bar / 20-120 psi. this appliance is configured to perform optimally at an operating pressure of 3 bar (45 psi) ±1⁄2 bar (7 psi); in case of a lower or higher operating pressure the performance may be affected negatively!
A Simplex system consists of 1 single softening module (pressure tank, resin, control valve and accessories). During normal operation, the Simplex system delivers softened water. As soon as it initiates a regeneration, it automatically goes into hard water bypass, guaranteeing uninterrupted supply of untreated water
Installation and Operation Manual. MP-MCA Top Mount Water Softeners with MCA100 Control Valve. July 2014 Version. Table of Contents. Performance Data Sheet. These softeners conform to NSF/ANSI 44 for the specific performance claims as verified and substantiated by test data. These models are efficiency rated.
The parts required to assemble and install the water softener are included with the unit. Thoroughly check the water softener for possible shipping damage and parts loss. Also inspect and note any damage to the shipping carton. Remove and discard (or recycle) all packing materials. To avoid loss of small parts, we suggest you keep the
1.2 Measure water hardness before/after appliance: • Open a cold water faucet before/after the appliance and let the water run for a few minutes. • Take a water sample and measure the water hardness; record the values on the Installation Record in the Owner’s Manual. • Close the cold water faucet.
All exchangers, ranging from a simple water softener to a complex mixed bed deionizer go through four basic regeneration steps. There may be variations in flow rates; types of regenerating chemicals and regenerant concentrations but these general steps are as follows: Backwash - Water flow is reversed so that it passes upward through the resin ...
