Αποτελέσματα Αναζήτησης
For these steel grades, flatness tolerance values shall be specified at the time of enquiry and order. In this section you will find conversion tables, a table comparing hardness values and correspondence tables between tensile strength and hardness.
ASTM A480 Plate Thickness & Flatness Tolerances. * Thickness is measured along the longitudinal edges of the plate at least 3/8 in. [9.52mm], but not more than 3 in. [76.20 mm], from the edge. ** For plates up to 10 in. [254.0mm], excl, in thickness, the tolerance under the specified thickness is 0.010 in. [0.25 mm].
Thickness is measured at any point more than 25mm from any edge, excluding ground areas. For thicknesses tolerances applicable where the surface was repaired by grinding, refer to EN 10163-2 (Delivery requirements for surface condition of hot-rolled steel plates). Data sheet: A1.4 Plate Mill Product Tolerances Hot rolled steel plate
This British Standard has been prepared under the direction of the Iron and Steel Standards Policy Committee and is the English language version of EN 10029 “Hot rolled steel plates 3 mm thick or above – Tolerances on dimensions, shape and mass”.
Thickness shall be measured at any point situated more than 25mm from the transverse or longitudinal edges of the plate, other than locally ground areas. For plates with untrimmed edges the measuring points shall be agreed at the time of order.
Hot-rolled steel plates 3 mm thick or above — Tolerances on dimensions and shape. NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW. raising standards worldwideTM. BS EN 10029:2010. BRITISH STANDARD. National foreword. This British Standard is the UK implementation of EN 10029:2010, incorporating corrigendum January 2012.
Browse Hot Rolled Steel Tolerances over/under specifications to find the right size and material for your next project at OnlineMetals.com.
